Integrated Solutions

  • D250S Dual

    CTEK the standard for DC t0 DC charging

    If you need a dual battery setup look no further

    The D250S Dual is what we call a DC to DC charging system. In this case with dual inputs, one from solar and one from an alternator. The solar input is up to 22VDC @ 25A, this outputs through the 20A 5 stage charging output profile and is considered the master input. The second input is from a vehicle's alternator which typically is supplying a voltage suited to the engine's management system or starting battery. Its almost never the correct charging voltage for what could be a flat house bank in the rear of the vehicle where the voltage drop over 3-5 metres could be 1 volt. This unit installed in the rear with the house batteries will ramp up the voltage to what's needed for the house battery to keep it well maintained at up to 20A, this is the slave input. By that we mean if you are in the sun the solar has priority charge of say 5A so that the engine doesn't need to work as hard to provide power for the other 15A that could be charging of the house batteries were flat. 

    If you have a newer Euro 5+ vehicle then you should consider reviewing the latest release from CTEK the D250SA with its ignition feed and wider operating alternator input voltages. 

  • D250SA

    Euro Performance Upgraded

    The latest from CTEK the D250SA leverages on the good foundation of the D250S Dual but raises the stakes again by including an ignition feed to only take energy from the start battery when the vehicle is running. An additional feature allows setting of bulk charging voltages at either 14.4V or 14.7V. A wider input voltage range on the alternator side for Euro 5+ engine for ECU controlled systems.

    A wider input voltage range on the alternator input side for Euro 5+ engine for ECU controlled systems allows for forced charging of the service batteries to optimise the engine output and generate charging power.

    MPPT Solar input, alternator input with service battery charging from the solar or engine with a preference on the suns free energy. Not to mention the ability to add the SmartPass or SmartPass 120 for an additional 80A or 120A charging output.

  • M100

    The all in one charger and power supply

    Flexible charging

    The smart and flexible M100 is perfect for tough marine environments as well as workshop or automotive uses..

    The M100 8 step 12V battery charger and maintainer can utilise the wide range of accessories from CTEK but comes with M10 eyelets as a point of difference from the MXS 7.0 which is essentially the same model. Its three selectable program modes make it suitable for use with 14-225Ah batteries and AGM batteries, and it can automatically detect whether your battery is near the end of its life. The M100 also has a Recond mode for reconditioning deeply discharged batteries and it can even be used as a 12V supply source, for example if you need to remove the battery without losing your settings or power an LED without a battery connected.

    • Charges batteries between 14-150Ah and up to 225Ah for maintenance charging
    • Temperature compensated charging via external temp sensor integrated into DC cable
    • Three programs – Normal, AGM and Recond
    • Can also be used as a 12V power source to protect electrical settings
    • Compact tough design
    • Fully automatic 8 step charging for maximum performance and extended life
    • Splash proof and dust proof (IP65)
    • Safe spark free operation
    • Short circuit proof
    • Reverse polarity protection
    • 5-year warranty

     

  • M200

    The perfect charger for all boat owners

    Quiet and flexible

    The M200 charges a wide range of marine batteries quickly and effectively.

    The M200 is the perfect 15A battery charger for all boat owners. It has a range of functions, including a Recond mode for reconditioning deeply discharged batteries including Wet and Ca/Ca, and a temperature sensor which optimises the charge if the temperature deviates from +25ºC. It also has a special Silent Night mode which reduces the noise of the fan by lowering the output power during periods of low energy consumption, such as at night. This mode automatically turns off after 8 hours to resume normal charging. The M200 comes with a long 4m cable with eyelets for easy installation on your boat or in your selected application.

    • Charges batteries from 28Ah up to 300Ah and maintains larger batteries up to 500Ah
    • Recond program for deeply discharged batteries or to equalise batteries in a string
    • Analysis step to check if battery can hold its charge (a sign of reduced capacity)
    • Temperature compensated
    • Short circuit proof
    • Compact tough design
    • Silent Night mode
    • IP44 rated, making it suitable for outdoor use in dry conditions
    • Safe spark free operation
    • 5-year warranty
  • M300

    The ideal choice for larger battery systems

    Compact, tough and powerful

    The M300 is recommended for those who need quick and effective charging for larger service batteries.

    The 12V, 25A M300 is the ideal choice for recovery charging and maintaining all types of batteries from 40Ah to 260Ah or maintenance charging up to 500Ah. It has a range of functions, including a Recond mode for reconditioning deeply discharged batteries or equalising, and a temperature sensor which optimises the charge if the temperature deviates from +25ºC. It also has a special Silent Night mode which reduces the noise of the fan by lowering the output power during periods of low energy consumption, such as at night. The M300 comes with a long 4m cable with eyelets for easy installation into a wired/integrated solution.

    • Charges and maintains batteries from 40Ah up to 500Ah.
    • Recond program for deeply discharged batteries
    • Analysis step to check if battery can hold its charge
    • Temperature compensated
    • Short circuit proof
    • Compact tough design
    • Silent Night mode
    • IP44 rated, making it suitable for outdoor use
    • Safe spark free operation
    • 5-year warranty
  • Off Grid Bundle

    Monitored charging to keep you off grid longer

    The CTEK 20A OFF GRID CHARGING SYSTEM charges your battery bank while you’re driving to stop it going completely flat so you can spend more time off grid. You can charge it from alternator, solar or wind power and, for complete peace of mind, you can see at a glance how much charge you’ve got left and the length of time till your batteries are discharged.

    D250S DUAL The D250S DUAL charger can get its energy from alternators, solar panels and wind power. It separates starter and service battery and maximizes the use of the both without risking that the starter battery is unable to start the engine. SYSTEM MONITOR The System Monitor constantly monitors the voltage and current (charge and discharge) to show you the exact how much charge you have and how many hours you’ve got left before your battery bank is empty.

  • Off Road Bundle

    The ultimate 12V power system for outdoor vehicles

    Battery to battery charger in a dual battery application

    Enjoy the outdoors for even longer with CTEK’s 100A OFF ROAD CHARGING SYSTEM. It combines the D250S Dual Smart Charger and the SMARTPASS Power Management System for the ultimate 12V power system. Install it in your 4WD, camper trailer or caravan to give you the best performance, power and life from your batteries.

    D250S DUAL The D250S DUAL charger can get its energy from alternators, solar panels and wind power. It separates starter and service battery and maximizes the use of the both without risking that the starter battery is unable to start the engine. SMARTPASS SMARTPASS is a Power Management System with under voltage protection that distributes it to the service batteries or electrical equipment. SMARTPASS separates and prioritized between critical and non-critical consumers to avoid drained service battery. SYSTEM MONITOR The System Monitor constantly monitors the voltage and current (charge and discharge) to show you exactly how much charge you have and how many hours you’ve got left before your battery bank is empty.

  • SmartPass

    More Power while you drive

    Fully automated control

    SMARTPASS controls and optimises energy and has a built in low voltage disconnect to make sure critical equipment such as radio, emergency lights and navigation systems always function. It’s suitable for boats, service vehicles, camper vans, caravans, RVs and heavy vehicles.

    SMARTPASS is a fully automatic power management system for controlling and optimising energy produced by alternators or conventional AC/DC chargers, which is then distributed to battery banks and consumers. It can handle up to 80A for batteries between 28-800Ah and is suitable for all types of 12V battery. It will only charge the house batteries when the DC circuit is being powered from a charging source so you never have to worry about a flat starting battery. When used with the D250S DUAL, SMARTPASS provides optimal charging through CTEK’s unique staged charging cycle to protect your battery.

    • Battery separation eliminates diodes and VSR relays
    • Delivers 80A for quick recharge of batteries 28-500Ah
    • Compatible with DUAL D250S and D250SA and delivers up to 100A charge when matched with either of these two units.
    • Prioritizing critical consumers and supplies consumers directly from the alternator
    • Splash and dust proof (IP65)
    • Suitable for boats, service vehicles, camper vans, caravans, RVs and heavy vehicles
    • Fully automatic
    • Simple to install and use
    • Maximizes battery life
    • Reduced charging times and costs
    • Separates consumers from service batteries for more effective charging
    • Temperature protection for service batteries
    • Safe spark free operation
    • Reverse polarity protected
    • Short circuit proof
    • 2-year warranty
  • SmartPass 120

    DC Battery Management System

    When you need to charge a large service battery bank or just better manage a situation where a second battery is needed. With an isolated low voltage disconnect circuit, you can ensure essential communication or navigation lights are left running while non-essential equipment is turned off to save the batteries power.

    The additional 120A of charging power means battery banks up to 1200Ah can be serviced with the addition of the D250SA solar input is also utilised to ensure maintenance charging is continued during storage or a period of non-use.