Marine

  • D250SA

    THIS MODEL IS NOW END OF LINE AND HAS BEEN REPLACED BY THE D250SE

    Euro Performance Upgraded

    The latest from CTEK the D250SA leverages the good foundation of the D250S Dual but raises the stakes again by including an ignition feed to only take energy from the start battery when the vehicle is running. An additional feature allows the setting of bulk charging voltages at either 14.4V or 14.7V. A wider input voltage range on the alternator side

    ...
  • M100

    The all in one charger and power supply

    Flexible charging

    The smart and flexible M100 is perfect for tough marine environments as well as workshop or automotive uses..

    The M100 8 step 12V battery charger and maintainer can utilise the wide range of accessories from CTEK but comes with M10 eyelets as a point of difference from the MXS 7.0 which is essentially the same model. Its three selectable program modes make

    ...
  • M200

    The perfect charger for all boat owners

    Quiet and flexible

    The M200 charges a wide range of marine batteries quickly and effectively.

    The M200 is the perfect 15A battery charger for all boat owners. It has a range of functions, including a Recond mode for reconditioning deeply discharged batteries including Wet and Ca/Ca, and a temperature sensor which optimises the charge if the

    ...
  • M300

    The ideal choice for larger battery systems

    Compact, tough and powerful

    The M300 is recommended for those who need quick and effective charging for larger service batteries.

    The 12V, 25A M300 is the ideal choice for recovery charging and maintaining all types of batteries from 40Ah to 260Ah or maintenance charging up to 500Ah. It has a range of functions, including a Recond mode for reconditioning

    ...
  • MXT 4.0

    The 24V maintenance charger for automotive marine or mobility

    Easy charging for 24V batteries

    The 8 step charger that’s ideal for smaller 24V batteries and maintenance charging for fleets with 24V vehicles.

    The MXT 4.0 is a cost effective 8 step charger that delivers 4A to 24V batteries from 8-100Ah and is suitable for maintenance charging up to 250Ah. It can also be used in applications such as

    ...
  • SmartPass 120

    DC Battery Management System

    THIS PRODUCT IS NOW END OF LINE AND HAS BEEN REPLACED BY THE SMARTPASS 120S.

    When you need to charge a large service battery bank or just better manage a situation where a second battery is needed. With an isolated low voltage disconnect circuit, you can ensure essential communication or navigation lights are left running while non-essential equipment is turned off to save the batteries

    ...